郁闷！签名款拾音器分FR和固定琴桥版本！
F-spacing refers to the wider of the two spacings. For proper string alignment and balanced output, F-spaced humbuckers should be used in the bridge position on all guitars with string spacing at the bridge of 2.1" (53 mm) or greater. On these guitars, if the nut width is 1-11/16? (43 mm) or greater, F-spaced pickups can be used in the neck position as well.Why are there two different spacings?
A long time ago (in the 20th century, actually) the electric guitar world was divided between Gibson and Fender designs. One of the differences between the two was string spacing. In general, Gibson chose a narrower string spacing at the bridge than Fender, and therefore the polepieces on Gibson humbuckers were closer together than the magnets on Fender pickups. When guitar shops started installing humbuckers in the bridge position of Strats, it was obvious that the strings didn?t line up with the polepieces, and if the E strings were too far outside, the sound could suffer. Our first humbuckers followed the original Gibson spacing, and we call them standard-spaced. When we released our first humbuckers with wider spacing, Floyd Rose bridges were very popular. Floyd string-spacing is the same as Fender spacing, so we naturally called the new pickups F-spaced.
How do I know which spacing to use?
F-spaced pickups measure 2.01" (51 mm) center-to-center from the first polepiece to the sixth. Standard-spaced pickups measure 1.90" (48 mm). Although some players believe that F-spaced pickups are only for the bridge position of tremolo bridge guitars, many guitars with fixed bridges (including late 1990s Gibson Les Pauls and Epiphone LPs) should have F-spaced pickups in the bridge position. Most tremolo equipped guitars that have a nut width of 1-11/16? (43mm) or more should also use an F-spaced pickup in the neck position. If you?re replacing a bridge-position pickup and you're not sure what your string-spacing is, it's usually better to get an F-spaced model. It is not necessary for the strings to pass exactly over the center of the polepieces for best performance, but it is wise to avoid a situation where the E strings are sitting completely outside of the outer polepieces.
我找一哥们给我在ebay上买alexi的EMG PU
等到定下了 过两天就到了
结果今天一搜索 仔细一看 发现 有ALX和F ALX 2个版本
我先是囧了半天 因为里面的图片和介绍都一样
就是最后有一句 The set is available in a Floyd Rose version (F-ALX) and a standard Tuneamatic version (ALX).
可是 我买的是ALX啊
然后用翻墙去了谷歌 找到了这个
才明白 原来双摇和无摇的拾音器 是有区别的
这真是雷死我了 那么多量产的拾音器 都不分双摇和无摇版本
到了一个只用一个拾音器一个vol的吉他手的signature拾音器上
他竟然分了
这样 拾音的范围 就少了3mm啊（F spacing是51 我搞普通版是48mm）
这能用吗？ 求斑竹和拾音器达人来，特别是对Jackson那种比普通拾音器大的拾音器有过研究的哥们过来帮我
[ 本帖最后由 Passivity 于 2010-8-11 15:48 编辑 ] 英文我就不翻译了 说了半天就是FR和LP的琴桥两根E弦距离是51mm fender等琴的E弦距离是48mm IBZ的双摇琴如果换Dimarzio的琴桥拾音器，一般都需要换F spaced的，否则会对不准磁芯。
回复 3# rocklover_2000 的帖子
那这下我杯具了 只能拿来就出掉了 没磁芯的、轨道式的就没这么多麻烦了……回复 5# tensu917 的帖子
哥们出给你吧回复 6# Passivity 的帖子
我琴也得用F的...回复 8# blithe6154 的帖子
我就知道你要来你也不说说这用起来有没有影响 1弦和6弦正常不
我这是赶上一哥们回国 根本不要代购和邮费 你回来看了再说，即使是f-spaced的，也不是百分百精确，当然你那个可能偏差更大点。 其实影响并没有那么大~ 主要是固定桥和双摇桥两根弦之间距离不同。那么，磁芯对不准，那功率就会有问题了，表现为中间的弦（对的较准）输出好，两边的输出一般。
像duncan sh13、dimarzio X2N/222的刀片式磁芯就不存在这个问题，两种桥都能用。 哥们，你确定那个拾音器不能退换吗？
回复 12# blithe6154 的帖子
哈哈 我有本来就有一个HZ H4啊把这两个都试一试 看看那个音色比较好
大哥以后还要多找你学习啊
14楼的哥们 EBAY的东西很难退的 杯具啊 半夜鸡叫？！
回复 18# rocklover_2000 的帖子
这么晚还泡GC 呵呵，泡gc不用花钱~
页:
[1]