Line6 Firehawk FX踏板校准操作步骤
从官网找到了Firehawkfx的踏板校准方法。此方法可以用于那些感觉哇音效果不明显，音量控制太敏感的情况。
随便翻译了一下。
1.关机状态下按住脚钉A，开机。直到显示屏出现“00”时，松开，这时脚钉D会亮起；
2.踩下脚钉D开始校准，显示屏画面会切换到“01”，脚钉D灯光熄灭；
3.用力踩下踏板至最低点并需要触发到踏板的切换开关（就是平时使用状态用来切换哇音的那个），这时屏幕会切换到“02”，脚钉D同时亮起；
4.把踏板踩到最高点（踏板前端抬起到最高点）；
5.踩一下脚钉D，显示屏会切换到“03”，脚钉D灯光会亮起；
6.把踏板踩到最低点（切勿触发踏板切换开关）；
7.踩下脚钉D，显示屏切换到画面“04”
8.现在上下踩一下踏板，观测屏幕上的数值变化，正常情况数值会在0和99之间滚动；
9.按下脚钉D保存设置，显示屏会显示“05”；
10.等待效果器自动重启，校准完成。
以下是英文原文。欢迎朋友们指正。
In case you need to perform a pedal calibration for your Firehawk FX. Here are the steps:
1. Hold down footswitch A while powering on the unit. At startup the display will show “00” and footswitch D LED will be lit.
2. Press footswitch D to begin. The display will change to “01” and footswitch D LED will turn off.
3. Press the pedal forward firmly to toggle the pedal toe switch. The display will change to “02” and footswitch D LED will be lit.
4. Move the pedal to the heel position.
5. Press footswitch D. The display will change to “03” and footswitch D LED will be lit.
6. Move the pedal to the toe position (do not click the toe switch).
7. Press footswitch D. The display will change to “04”.
8. Move the foot pedal and watch the values change on the display. Values will scroll from a min. of 0 to a max. of 99.
9. Press footswitch D to save the calibration values. The display will change to “05”.
10. Power cycle the unit and your pedal is calibrated.
页:
[1]