|
|
发表于 2012-9-15 21:09:20
|
显示全部楼层
童鞋，要有中文说明书的话看明白再用啊，别着急，我没用过digitech的，但所有效果器FX意思就是Effect的意思，一直按Exit那种键不行么。再不行，都能恢复成出厂设置的，不用急。
。我在官网查的1. Press and hold the Store button while powering up the RP355.
2. When the display prompts you with FACRST, release the Store button, which is now flashing.
3. Press and hold the flashing Store button for 3 seconds until RSTORD appears in the display
and release. The Restore procedure takes several seconds to complete; during the procedure,
the display will count up. After the Restore procedure is complete, the Expression Pedal calibration
procedure will begin. See step two of the Expression Pedal Calibration section below.
大概意思是首先启动RP355的同时按住Store键不放，当显示FACRST（factory reset），然后松开正在闪烁的Store键，再按住该键持续三秒直到显示RSTORD松开，重新储存过程将持续几秒并且显示屏会计数，完成后表情踏板校准程序会开启，参照下面有关的第二部分。（我晕，好麻烦，不过功能很强大，可以调节哇哇踏板的灵敏度）
2. When the Display prompts you with TOE DN, rock the Expression Pedal forward (toe
down) and press either the Up or Down Footswitch.
3. When the Display prompts you with TOE UP, rock the Expression Pedal back (toe up) and
press either the Up or Down Footswitch.
4. The Display now prompts you to calibrate the V-Switch sensitivity (VSwxxx), where XXX is
the current V-Switch threshold. Rock the Expression Pedal forward and press firmly on the
toe once to turn the V-Switch on (wah ON), and again to turn the V-Switch off (wahOFF).
5. If the V-Switch is too sensitive, press the right Up Footswitch to raise the threshold (range
is 0-200). Keep testing the V-Switch sensitivity and adjust the threshold until it only engages
when you want it to (too sensitive a setting will lead to the V-Switch falsely triggering on or off
when using the Expression Pedal).
6. When the V-Switch sensitivity is set to your satisfaction, press both Up/Down Footswitches
simultaneously to exit.
Note: If the Display shows error, an error has occurred and steps 2 through 5
should be repeated.
[ 本帖最后由 iamliudawei 于 2012-9-15 21:13 编辑 ] |
|
，真心的，多看看说明，你会发现也许很多东西你还未了解。
