|
|
楼主 |
发表于 2007-7-5 15:29:39
|
显示全部楼层
LSR的上弦也很容易的
String Installation:
1. Turn the tuning knob clockwise until the string hub ejects from the tuner housing. A click or snap will be heard as the hub ejects to its stop point. Continue turning in this direction about two full turns after you hear the click. (You may feel some initial resistance at this point. This is normal.) This will disengage the string lock system.
2. Thread the string through the passage. While the string is pulled taut, turn the tuning knob counterclockwise until you feel the string lock system clamp the string into the hub. See FIG.4.
3. Bend the excess string over as shown in FIG.5 With your fingertip, push the string hub back into the tuner while turning the tuning knob in the counterclockwise direction until you feel the string hub begin to recede into the body of the tuner. Leave a little of the string exposed and cut off the excess at the end of the hub, as shown in FIG.6.
4. Tune the string to pitch. Repeat the same process for each additional string. See FIG.6.
|
|
发表于 2007-7-5 04:49:52
